iC Elea logo
iC Elea logo negative
  •  
  • Technical Fields
    • Structural Engineering
    • Tunnels and Geotechnics
    • Architecture
    • Civil Engineering Constructions
    • Geology and Hydrogeology
    • Project Management and Supervision
  • References
    • Structural Engineering
    • Tunnels and Geotechnics
    • Architecture
    • Civil Engineering
    • Geology and Hydrogeology
    • Project Management and Supervision
  • BIM
  • Company
  • Jobs
  • Contact
  • ENG
    • SLO
  • Search

Slovenian Institute for Quality and Metrology Ljubljana

The existing building consisted of two separated dilatations. The administrative part with a basement, a ground floor and two upper floors with floor dimensions 18.0 x 46.0 m and the storage part of the building with a basement, a ground floor and one upper floor with floor dimensions 42.0 x 46.0 m. The height of the administrative part of the building from the ground to the ridge was approx. 14.0 m, and the storage area height was approx. 9.5 m. After the reconstruction, the floor plans and the height of the building remained unchanged. The existing building was designed as a prefabricated reinforced-concrete structure with columns in a 6.0 x 11.5 m raster, through which prestressed beams and prefabricated plates were laid.
During the reconstruction, a new steel floor was constructed in the existing storage facility. In addition to the new steel floor construction, a new interior staircase along the east facade wall was carried out, the reconstruction of the outer staircase for the northern part of the building and the increase in the installation platforms on the roof. In the administrative part of the building, a new staircase was built with an elevator shaft. The central staircase was removed and replaced by a new reinforced-concrete communication core. On the south side of the building, a new roof with an entrance staircase was build.
With new interventions, loads on the existing structures were not generally increased, except in some local areas, where the increase in the load was solved by the implementation of new supports (walls, columns and beams).
Due to the inadequate earthquake resistance of the building, new evenly distributed concrete walls were implemented along the periphery of the building.


Project typeOffice buildingLocationLjubljana, SloveniaArea10.000 m²Inv. value8.000.000,00 €Year(s)2015-2017Servicesstructural design: building permit design, detail design, tender design, as build designArchitectureTrije arhitekti d.o.o.InvestorSlovenian Institute for Quality and MetrologyPhotosMiran Kambič

Share

About iC Group

Elea iC is a member of an interdisciplinary consulting group iC based in Vienna, through which we extend the scope of our offer and combine knowledge, experience and expertise.
www.ic-group.org

Services

  • Structural Engineering
  • Architecture
  • Civil Engineering
  • Geology and Hydrogeology
  • Project Management

Support Pages

  • Contact
  • Jobs
  • Policy Statement
  • Privacy Policy
  • Cookies
  • Sitemap

Contact

ELEA iC engineering and consulting d.o.o.
Dunajska cesta 21, SI-1000 Ljubljana

Tel +386 1 474 10 00
info@elea.si
www.elea.si

© 2018, Elea iC. All rights reserved.  |  Privacy Preferences

This website uses cookies to improve your browsing experience.

Privacy Preference Center

Privacy Preferences

When you visit any website, it may store or retrieve information through your browser, usually in the form of cookies. Since we respect your right to privacy, you can choose not to permit data collection from certain types of services. However, not allowing these services may impact your experience.

Privacy Policy

Required
You read and agreed to our Privacy Policy.

Tracking

Required
We use the Google Analytics service to measure traffic on our website. No personal information is transferred, not even your IP address.

YouTube

We use the YouTube service to enable video content streaming on this site.